Condenser HVAC: Service and Repair
REMOVALThe condenser is located between the radiator and the front bumper. The condenser can be serviced without having to drain the cooling system or removal of the radiator.
WARNING: AVOID BREATHING A/C REFRIGERANT AND LUBRICANT VAPOR OR MIST. EXPOSURE MAY IRRITATE EYES, NOSE AND THROAT. USE ONLY APPROVED SERVICE EQUIPMENT MEETING SAE REQUIREMENTS TO RECOVER R-134a SYSTEM IF ACCIDENTAL SYSTEM DISCHARGE OCCURS, VENTILATE WORK AREA BEFORE RESUMING SERVICE.R-134a SERVICE EQUIPMENT OR VEHICLE A/C SYSTEM SHOULD NOT BE PRESSURE TESTED OR LEAK TESTED WITH COMPRESSED AIR. SOME MIXTURES OF AIR/R-134a HAVE BEEN SHOWN TO BE COMBUSTIBLE AT ELEVATED PRESSURES. THESE MIXTURES ARE POTENTIALLY DANGEROUS AND MAY RESULT IN FIRE OR EXPLOSION CAUSING INJURY OR PROPERTY DAMAGE.
1. Recover the refrigerant from the A/C system using a refrigerant recovery machine.
Fig. 1 Condenser Inlet:
2. Disconnect and cap or tape the A/C line at condenser inlet.
Fig. 2 Condenser Outlet:
3. Disconnect and cap or tape the A/C line at the condenser outlet.
4. Remove the upper radiator support bars and cross-member.
5. Remove the condenser lines. Use Special Tool kit 7193 (or equivalent) for quick disconnect couplers.
6. Remove the radiator fan module.
Fig. 3 Condenser Mounting (typical):
7. Remove the condenser mounting screws.
8. Lift radiator out of the lower mounting brackets. It is not necessary to drain radiator. Condenser lower mounting bracket is trapped between the radiator lower isolator and plastic radiator tank pin. It is necessary to lift and push down on the condenser to free condenser bracket from radiator pins.
9. Lift the condenser from the vehicle.
INSTALLATION
1. Lift the condenser and place it into the vehicle.
2. Lift the radiator out of the lower mounting brackets. It is not necessary to drain radiator. The condenser lower mounting bracket is trapped between the radiator lower isolator and the plastic radiator tank pin. It is necessary push down on the condenser to install the condenser bracket to the radiator pins. Reinstall the radiator to its mounting brackets.
3. Install the condenser mounting screws.
4. Install the radiator fan module.
5. Install the condenser line, remove caps or tape from lines. Use Special Tool kit 7193 (or equivalent) for quick disconnect couplers.
6. Install the upper radiator support bars and cross-member.
7. Connect the A/C line at the condenser outlet.
8. Connect the A/C line at the condenser inlet.
9. Evacuate the refrigerant system.
10. Recharge the refrigerant system.