Fuel Injector: Service and Repair
REMOVAL1. Release fuel pressure.
2. Disconnect the negative battery cable.
3. Remove air cleaner housing and inlet hose.
4. Remove engine cover.
Throttle Body:
5. Disconnect the Throttle Position Sensor.
6. Disconnect the Idle Air Control.
7. Disconnect the purge line.
8. Disconnect the throttle and speed control cables (if equipped).
Map Sensor:
9. Unlock and disconnect the MAP sensor.
10. Disconnect the vacuum lines.
11. Remove the EGR tube.
Intake Manifold Removed:
12. Remove the upper intake manifold.
Fuel Rail:
13. Fuel Rail, wiring harness and injectors.
Fuel Injector Location:
14. Injector and electrical connector.
Fuel Injector Wiring Harness:
15. If the injector connectors are not tagged with their cylinder number, tag them to identify the correct cylinder.
Fuel Rail Bolts Locations:
16. Remove the 4 mounting bolts from the fuel rail.
Fuel Line Disconnect Fitting:
17. Disconnect the fuel supply line from the fuel rail.
Fuel Rail Assembly:
18. Lift fuel rail straight up off of cylinder head.
Fuel Injector Clip:
19. Remove retaining clips from fuel injectors at fuel rail.
Fuel Injector And Clip:
20. Remove fuel injector from fuel rail.
INSTALLATION
Fuel Injector And Clip:
1. Inspect and replace damaged fuel injector O-rings.
2. Lightly lubricate the fuel injector O-rings with a couple drops of clean engine oil.
Fuel Injector O-ring:
3. Install retaining clips on fuel injectors.
Fuel Rail Locator Tabs:
4. Fuel injector locator flange on fuel rail.
Installing Fuel Injector:
5. Push injectors into fuel injector rail until clips are in the correct position.
Fuel Injector Clip:
6. Fuel injector installed into fuel rail in the correct position.
Fuel Injectors Installed:
7. Fuel rail with injectors installed.
Fuel Rail Bolts Locations:
8. Position fuel rail over cylinder heads, and push rail into place. Tighten fuel rail mounting bolts to 28 N.m (250 in. lbs.) torque.
9. Connect the electrical connectors to the fuel injectors and lock.
Fuel Line Disconnect Fitting:
10. Connect the fuel supply tube quick connect fitting to the fuel rail.
Intake Gaskets Removed:
11. Inspect the intake manifold gaskets.
Intake Gasket Installed:
12. Intake manifold gaskets installed.
Intake Manifold Removed:
13. Install intake manifold plenum.
14. Connect and lock the electrical for the MAP sensor (1).
Map Sensor:
15. Connect the vacuum lines (2).
Throttle Body:
16. Connect the electrical connector for Throttle Position Sensor (2), Idle Air Control Motor (3).
17. Connect the purge line (1).
18. Connect negative cable to battery.