Rear Wiper Motor Replacement
REMOVAL1. Disconnect and isolate the battery negative cable.
2. Remove rear wiper arm.
3. Open liftgate, remove liftgate trim panel.
Rear Wiper Motor Electrical Connector:
4. Disconnect the rear wiper motor electrical connector.
Rear Wiper Motor - Remove/Install:
5. Remove the three rear wiper motor mounting screws.
6. Remove rear wiper motor from lift gate/vehicle.
INSTALLATION
Right (wiper) Multi-Function Switch Typical:
1. Position the rear wiper motor into position on the liftgate and install the three rear wiper motor mounting screws. Torque screws to 6 ± 1 Nm (55 ± 10 in. lbs.).
2. Connect the rear wiper motor electrical connector.
3. Install the liftgate trim panel.
4. Install the rear wiper arm.
5. Connect the battery negative cable.
6. Verify vehicle and system operation.