A/C - Intermittent Loss of A/C/Heater Display
NUMBER: 24-007-04GROUP: Heating and Air Conditioning
DATE: December 13, 2004
SUBJECT:
Loss of HVAC Display
OVERVIEW:
This bulletin involves replacing the A/C and Heater Control.
MODELS:
2004 (CS) Pacifica
NOTE:
This bulletin applies to vehicles built on or before September 23, 2003 (MDH 0923XX).
SYMPTOM/CONDITION:
The vehicle operator may experience the A/C and Heater Control display intermittently going blank.
DIAGNOSIS:
If the vehicle operator describes the Symptom/Condition, perform the Repair Procedure.
PARTS REQUIRED:
SPECIAL TOOLS/EQUIPMENT REQUIRED:
REPAIR PROCEDURE:
1. Disconnect and isolate the negative battery cable.
2. Remove ignition switch bezel
3. Using a trim stick C-4755 or equivalent, disengage the locking tabs attaching instrument panel center bezel right and left side.
4. Remove the three screws that secure the A/C-heater control to the instrument panel.
5. Remove the A/C-heater control from the instrument panel and disconnect the two wire harness connectors from the control.
6. Position the new AC-heater control, p/n 05005064AJ, in the instrument panel.
7. Connect the two wire harness connectors to the back of the A/C-heater control.
8. Install the AC-heater control into the instrument panel.
9. Install the three screws that secure the AC-heater control to the instrument panel. Tighten the screws to 2 N.m (17 in. lbs.).
10. Engage the locking tabs attaching instrument panel center bezel on the right and left side and install both bezels.
11. Install the ignition switch bezel.
12. Reconnect the negative battery cable.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.