Heated Seat Sensor - Front Seats
For complete circuit diagrams, refer to WIRING.1. Locate the memory heated seat adjustable pedal module. Refer to the Electronic Control Module section for information.
2. Back-probe the memory heated seat adjustable pedal module wire harness connector, do not disconnect. With the heated seat system "ON", check the heated seat temperature sensor input cavity for a range in voltage from approx. 1.72 - 3.0 volts. It should be within this range, If OK go to Step 3. If NOT OK, check for the proper 5 volt supply to the heated seat sensor, from the module. Refer to the Wiring section for specific information. If 5 volts is not being supplied to the sensor from the module, replace the memory heated seat adjustable pedal module.
3. Test the seat wire harness between the module connector and the heated seat element wire harness connector for shorted or open circuits. If OK, refer to Diagnosis and Testing the Heated Seat Element, for the proper heated seat element diagnosis and testing procedures. If not OK, repair the shorted or open heated seat wire harness as required.