Operation CHARM: Car repair manuals for everyone.

Removal and Installation





1. Remove guide pin. Lift caliper assembly, slide the assembly toward the inside of the wheel well until separated from the lock pin. Support it with wires or similar material.

CAUTION: Do not wipe off the special grease that is on the guide pin or allow it to contaminate the lock pin.

Removing Pad And Shims From Caliper Support:





2. Remove the following parts from caliper support:

a. Pad & wear indicator assembly (1).
b. Pad assembly (2).
c. Clip (3).
d. Outer shim (stainless) (4).
e. Outer shim (coated with rubber) (5).
f. Inner shim (stainless) (6).
g. Inner shim (coated with rubber) (7).





3. For front brake, apply grease to the attaching faces of pad and inner shim and to the attaching faces of inner and outer shims. Apply so as not to spread it out from the edge of shim.

Specified grease: MOPAR Multipurpose Grease Part No. 2932524 or equivalent

CAUTION:
a. Do not deposit grease or other dirt on pad or brake disc friction surfaces.
b. Apply the grease so that it does not protrude from the shim surfaces.

4. Measure hub torque with pads removed to measure brake drag torque after pad installation.
5. Install the pad and caliper assembly, and then check the brake drag force.