Operation CHARM: Car repair manuals for everyone.

Parking Brake System: Adjustments


Parking Brake Pedal Cable Routing:






SERVICE PROCEDURES

ADJUSTING PARKING BRAKE
The parking brake foot lever assembly used on all L.H. platform vehicles, with and without rear disc brakes contain a self adjuster for the cable system. Routine parking brake cable adjustment on all L.H. platform vehicles is not required.

WARNING:
- THE SELF ADJUSTING FEATURE OF THIS PARKING BRAKE LEVER ASSEMBLY CONTAINS A CLOCK SPRING LOADED TO APPROXIMATELY 8 POUNDS. CARE MUST BE TAKEN TO PREVENT EXCESSIVE JARRING OF THE ASSEMBLY.
- DO NOT RELEASE THE SELF ADJUSTER LOCKOUT DEVICE BEFORE INSTALLING CABLES INTO THE EQUALIZER.
- KEEP HANDS OUT OF SELF ADJUSTER SECTOR AND PAWL AREA.
- FAILURE TO OBSERVE CAUTION IN HANDLING THIS MECHANISM COULD LEAD TO SERIOUS INJURY.

When repairs to the foot lever assembly or front cable are required the self adjuster must be reloaded and locked out.

SELF ADJUSTING PROCEDURES

Winding Park Brake Sector Spring:






RELOADING SELF ADJUSTER
1. Insert a 1/4 in drive ratchet and extension into 1/4 in square hole located in sector of park brake pedal mechanism.
2. Pull on ratchet and extension, rotating sector toward rear of vehicle until ratchet extension contacts back of park brake pedal. This will fully wind sector spring.

Locking Pin Installed In Park Brake Mechanism:






3. Insert a pin or drill bit into park brake lever mechanism to lock sector in place. Pin used to lock sector, should be 1/8 in. in diameter by 2 inches long to go through both sides of park brake mechanism.
When repairs are complete, adjust rear brake, before adjusting parking brake. On drum-in-hat type of rear disc brake adjust shoe diameter to 171.5 mm (8.75 inch).

PARKING BRAKE ADJUSTING PROCEDURE
Be sure that all 3 park brake cables are properly assembled to the equalizer bracket prior to cable adjustment.

Park Brake Cable Routing In Pedal Assembly:






Be sure park brake cable is properly seated on the park brake mechanism cam surface.

Note:
- The parking brake pedal must he in the fully released position when releasing self adjuster.

Using a pair of pliers, firmly grasp lock pin previously installed in park brake mechanism. Remove lock pin from park brake pedal mechanism, by pulling it firmly and rapidly from the park brake mechanism.

Park Brake Cable Installed In Mechanism:






Apply and release the park brake lever several times. The rear wheels should rotate freely without dragging.