Window Regulator: Service and Repair

REMOVAL STEPS
1. Door trim
2. Waterproof film
3. Door drip moulding
4. Door belt moulding
5. Door window rear sash moulding
6. Door belt inside weatherstrip
7. Door glass stabilizer (inner)
8. Door glass stabilizer (outer)
9. Front door glass
10. Power window regulator
11. Power window motor

SERVICE POINTS OF REMOVAL
1. Removal Of Door Trim
Refer to Door Panel/Service and Repair.





2. Removal Of Waterproof Film
Cut away the non-drying adhesive around the waterproof film with a cutter or similar tool.

CAUTION: If the clip for the door trim is still in the mounting hole in the body, remove it with the tool shown in the illustration.





3. Removal Of Door Drip Moulding
Insert the trim stick at the position of the moulding clips, and then pry the mouldings to remove them in the following order:

1. Door drip moulding
2. Door belt moulding
3. Door window rear sash moulding





9. Removal Of Front Door Glass
1. Turn on the ignition switch and operate the windows. Be sure to turn the ignition switch off after finishing.
2. Remove the door glass stabilizer.
3. Remove the glass mounting nuts.
4. Pull the glass upward and remove it.





10. Removal Of Power Window Regulator
1. Remove the door glass guide.





2. Remove the door glass guide through the access hole while moving the lower edge of the guide forward.
3. Remove the motor connector.





4. Remove the regulator mounting bolts.
5. Remove the regulator through the access hole.

SERVICE POINTS OF INSTALLATION





10. Application Of Grease To Power Window Regulator
Apply the specified grease to the door glass guide and guide piece.

Specified grease: MOPAR Multi-mileage lubricant Part No. 2525035 or equivalent





9. Installation Of Front Door Glass
1. Lower the power window regulator until the door glass and regulator installation point is visible through the service hole.
2. install the door glass to the power window regulator and temporarily tighten the nuts.
3. Loosely tighten nuts A.
4. After making the adjustment of the door glass tilt, tighten nuts A.





8. Installation Of Door Glass Stabilizer
Install the door glass stabilizers to the door panel at the positions shown in the illustration.





2. Application Of Sealant To Waterproof Film
Apply the specified sealant at the position shown in the illustration, and then attach the waterproof film.

Specified Sealant: MOPAR Rope Caulk Sealer 3/16 x 80" roll Part No. 4026044 or equivalent.