Timing Cover: Service and Repair
1985
Removal
1. Remove drive belts and pulley.
2. Raise and support vehicle.
3. Remove crankshaft pulley, then the damper retaining bolt.
4. Remove torsional damper using tool No. J-23523-1 or equivalent.
5. Remove water pump as described under ``Water Pump, Replace.''
6. Remove front cover attaching bolts, then the front cover and gasket. Discard gasket.
Installation
1. Clean gasket surface on front cover and block.
2. Remove any excess gasket material protruding at oil pan-to-engine block junction using a suitable cutting tool.
3. Apply a 1/8 inch bead of RTV sealant to joint formed at oil pan and block.
4. Apply suitable gasket sealant to gasket and place in position on cover.
5. install cover-to-oil pan seal, then lightly coat bottom of seal with clean engine oil.
6. Position cover over crankshaft end, then loosely install cover-to-block attaching screws.
7. Tighten attaching screws alternately and evenly while pressing down on cover so dowels in block align with holes in cover. Do not force cover over dowels so that cover flange or holes are distorted.
8. Install remaining screws and torque to 7 ft. lbs.
9. Install torsional damper and water pump.