Shifter A/T: Service and Repair

Gearshift Control Lever Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution in Cautions and Notices.




1. Disconnect the negative battery cable.
2. Remove the floor console. Refer to Front Floor Console Replacement Front Floor Console Replacement in Interior Trim.
3. Disconnect the electrical switch connector.




4. Remove the shift control cable adjuster pinch nut.
5. Loosen the nut from the shift control cable mounting bracket on the shift control assembly.
6. Remove the cable from the bracket.




7. Remove the 4 bolts holding the shift control assembly to the floor panel.
8. Remove the shift control assembly.

Installation Procedure





Notice: Refer to Fastener Notice Fastener Notice in Cautions and Notices.

1. Install the shift control assembly with 4 bolts.

Tighten the bolts to 8 Nm (71 lb in).




2. Install the shift control cable onto the bracket and tighten the nut.
3. Install the shift control cable adjuster pinch nut.

Tighten the nut to 8 Nm (71 lb in).




4. Connect the electrical switch connector.
5. Install the floor console. Refer to Front Floor Console Replacement Front Floor Console Replacement in Interior Trim.
6. Connect the negative battery cable.