Rear Disc Brake Pads Replacement

Rear Disc Brake Pads Replacement

Removal Procedure





Caution: Refer to Vehicle Lifting Caution Vehicle Lifting Caution.

Notice: Refer to Vehicle Lifting and Jacking Notice Vehicle Lifting and Jacking Notice.

1. Raise and suitably support the vehicle.
2. Remove the rear wheels. Refer to Tire and Wheel Removal and Installation Service and Repair.

Important: Caliper removal is not necessary to service the brake pads.


3. Remove the lower caliper guide pin bolt.




4. Pivot the caliper upward.
5. Remove the brake shoes.

Installation Procedure




1. Measure the minimum brake shoe lining thickness. Refer to Brake Pad Inspection Testing and Inspection.
2. Install the brake shoes into the caliper.
3. Push the piston inward, if needed.





Notice: Refer to Fastener Notice Fastener Notice.

Important: Avoid damaging the piston seal when the piston housing is pulled down.


4. Pivot the caliper downward and install the bolt.

Tighten the lower caliper mounting bolt to 31 Nm (23 lb ft).

5. Install the rear wheels. Refer to Tire and Wheel Removal and Installation Service and Repair.
6. Lower the vehicle.