Rear Door Lock Replacement

Rear Door Lock Replacement

Removal Procedure





Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Remove the door seal trim. Refer to Door Bottom Auxiliary Sealing Strip Replacement Door Bottom Auxiliary Sealing Strip Replacement.
3. Remove the screw and the guide rail.




4. Remove the door lock screws.
5. Disconnect the lock rods.
6. Remove the door lock.
7. Disconnect the electrical connector.

Installation Procedure




1. Connect the electrical connector.

Notice: Refer to Fastener Notice Fastener Notice in Cautions and Notices.

2. Install the rear door lock with the screws.

Tighten the rear door lock screws to 10 Nm (89 lb in).




3. Install the lock rods.
4. Install the guide rail with the bolts and the screw.

* Tighten the rear door guide rail screw to 4 Nm (35 lb in).
* Tighten the rear door guide rail bolts to 10 Nm (89 lb in).

5. Install the door seal trim. Refer to Door Bottom Auxiliary Sealing Strip Replacement Door Bottom Auxiliary Sealing Strip Replacement.
6. Connect the negative battery cable.