Condenser Tube Replacement
TOOLS REQUIREDJ 39400-A Halogen Leak Detector
REMOVAL PROCEDURE
1. Recover the refrigerant.
2. Remove the air cleaner assembly.
3. Remove the cross vehicle brace.
4. Remove the vacuum brake booster.
5. Remove the condenser tube from the support bracket.
6. Remove the lower radiator air baffle.
7. Remove the condenser tube nut from the condenser.
8. Disconnect the condenser tube from the condenser.
9. Lower the vehicle.
10. Disconnect the electrical connector from the A/C refrigerant pressure sensor.
11. Loosen the evaporator tube nut from the condenser tube.
12. Disconnect the evaporator tube from the condenser tube.
13. Remove the condenser tube.
14. Remove and discard the O-ring.
15. Remove the A/C pressure sensor from the condenser tube.
INSTALLATION PROCEDURE
1. Install the A/C pressure sensor to the condenser tube.
2. Install the new O-ring onto the condenser tube.
3. Install the condenser tube to the support bracket.
4. Connect the condenser tube to the evaporator tube.
5. Tighten the evaporator inlet tube nut.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nut to 27 N.m (20 lb ft).
6. Connect the electrical connector to the A/C refrigerant pressure sensor.
7. Raise and support the vehicle. Refer to Vehicle Lifting.
8. Connect the condenser tube to the condenser. Tighten the condenser tube nut.
Tighten
Tighten the nut to 27 N.m (20 lb ft).
9. Install the lower radiator air baffle.
10. Install the vacuum brake booster.
11. Install the cross vehicle brace.
12. Install the air cleaner assembly.
13. Evacuate and recharge the A/C system.
14. Leak test the fittings of the component using J 39400-A.