Air Distribution Duct
REMOVAL PROCEDURE1. Remove the I/P lower trim panel.
2. Remove the retaining screw (1) from the panel air distribution duct.
3. Remove the retaining bolts from the panel air distribution duct.
4. Remove the panel air distribution duct from the cross vehicle beam.
5. Reposition the right I/P fuse junction block.
6. Remove the retaining bolts from the right air distribution duct.
7. Remove the right air distribution duct from the cross vehicle beam.
INSTALLATION PROCEDURE
1. Install the right air distribution duct to the cross vehicle beam.
2. Install the right air distribution duct bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 10 N.m (89 lb in).
3. Install the right I/P fuse junction block.
4. Install the panel air distribution duct to the cross vehicle beam.
5. Install the panel air distribution duct screw (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screw (1) to 1.8 N.m (16 lb in).
6. Install the panel air distribution duct bolts.
Tighten
Tighten the bolts to 10 N.m (89 lb in).
7. Install the I/P lower trim panel.