Engine Oil Cooler Hose/Pipe Replacement
Engine Oil Cooler Hose/Pipe ReplacementRemoval Procedure
1. Remove the engine oil cooler from the vehicle.
2. Remove the right engine splash shield.
3. Remove the engine oil cooler lines from the engine oil filter adapter.
4. Remove the engine oil cooler line mounting bolt (1).
5. Remove the engine oil cooler line mounting block (2).
6. Cut and remove the tie strap that holds tale engine oil cooler lines to the frame.
7. Remove the engine oil cooler lines from the vehicle.
Installation Procedure
Important: Route the engine oil cooler lines tinder the battery cable.
1. Install the engine oil cooler lines to the vehicle.
2. Install the engine oil cooler to the vehicle.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Install the engine oil cooler lines to the engine oil filter adapter.
5. Install the engine oil cooler line mounting block, to the engine oil cooler lines.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the bolt (1) through the engine Oil Cooler line mounting block.
^ Tighten the bolt to 3.4 Nm (30 in lb).
7. Install a new tie strap around the engine oil cooler lines and frame.
8. Install the right engine splash shield. Add the proper amount of engine oil