Fuse and Relay Block 1

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly.
3. Remove the 2 bolts that hold fuse and relay block 1 (1) to the inner tender.
4. Carefully pull fuse and relay block 1 away from the inner fender and unsnap the lower cover.
5. Disconnect each of the harness connectors.
6. Remove fuse and relay block 1 from the vehicle.

INSTALLATION PROCEDURE




1. Install fuse and relay block 1 (1) to the vehicle.
2. Connect each connector to fuse and relay block 1.
3. Install the lower cover.
4. Install fuse and relay block 1 to the inner fender. Secure with the 2 bolts.
5. Install the air cleaner assembly.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Connect the negative battery cable.

Tighten
Tighten the negative battery cable to 15 N.m (11 lb ft).