Operation CHARM: Car repair manuals for everyone.

Valve Cover: Service and Repair

Valve Rocker Arm Cover Replacement

Removal Procedure





1. Remove the negative battery cable.
2. Remove the resonator and duct assembly.





3. Remove the resonator bracket/fuel rail cover.





4. Remove left engine wiring harness retainer bracket nut and bracket.
5. Remove wiring harness from retainer on valve rocker arm cover.
6. Remove the valve rocker arm cover bolts.
7. Remove the valve rocker arm cover.
8. Clean the sealing surface on the cylinder head and the valve rocker arm cover.

Installation Procedure





Notice: Refer to Fastener Notice in Service Precautions.

1. Install the valve rocker arm cover.
2. Install the valve rocker arm cover bolts.
^ Tighten the bolts to 10 Nm (89 inch lbs.).





3. Install the resonator bracket/fuel rail cover.
4. Install the resonator bracket/fuel rail cover nuts.
^ Tighten the nuts to 25 Nm (18 ft. lbs.).





5. Install wiring harness to retainer on valve rocker arm cover.
6. Install wiring harness retainer bracket and nut.
7. Install the resonator and duct assembly.
8. Connect the negative battery cable.
^ Tighten the bolt to 16 Nm (12 ft. lbs.).