Operation CHARM: Car repair manuals for everyone.

Water Pump: Service and Repair

Water Pump Replacement

- Tools Required
- J 36660-A Torque Angle Meter Removal Procedure





1. Drain the cooling system.
2. Loosen the water pump pulley bolts.
3. Remove the drive belt.
4. Remove the water pump pulley bolts.
5. Remove the water pump pulley.
6. Remove the power steering pump and reposition.





7. Remove the water pump bolts.





8. Remove the water pump.
9. Remove the water pump gasket.
10. Clean and inspect the water pump mating surfaces.

Installation Procedure





1. Install the water pump gasket.
2. Install the water pump.

Notice: Refer to Fastener Notice in Service Precautions.





3. Install the water pump bolts.
- Tighten the long water pump bolts to 20 Nm (15 ft. lbs.) plus 40 degrees
- Tighten the short water pump bolts to 15 Nm (11 ft. lbs.) plus 80 degrees.





4. Install the water pump pulley.
5. Install the water pump pulley bolts.
- Tighten the water pump pulley bolts to 13 Nm (115 inch lbs.).
6. Install the power steering pump. Refer to Power Steering Pump Replacement (3.4L) or Power Steering Pump Replacement (3.8LL) in Power Steering System.
7. Install the drive belt.
8. Fill the cooling system.
9. Inspect for leaks.