Operation CHARM: Car repair manuals for everyone.

Procedures

Valve Rocker Arm and Push Rod Replacement

Removal Procedure





1. Remove the valve rocker arm cover(s).
2. Remove the rocker arm bolt(s).
3. Remove the valve rocker arm(s) and the pushrod(s).

Installation Procedure





1. Coat the ends of the push rods using prelube GM P/N 1052365 or the equivalent.

Important: The intake valve push rods measure 144 mm (5.75 inch) in length, (yellow).

2. Install the push rods in their original location. The exhaust valve push rods measure 152.5 mm (6.0 inch) in length, (green).





3. Coat the rocker arm friction surfaces using prelude GM P/N 1052365 or the equivalent.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the valve rocker arm bolts. See TSB 02-06-01-034
- Use the J 36660-A to tighten the valve rocker arm bolts to 14 Nm (124 in. lbs.) plus 30 degrees.
5. Install the valve rocker arm cover(s).