Automatic Transaxle-3T40

Floor Shift Control Replacement

Removal Procedure

1. Disconnect the battery negative cable.
2. Remove the automatic transmission control lever handle retainer.





3. Remove the automatic transmission control lever handle.
4. Remove the console.





5. Remove the range select lever cable from the automatic transmission control.
6. Remove the electrical connector.





7. Remove the automatic transmission control nuts.
8. Remove the automatic transmission control.

Installation Procedure





1. Install the automatic transmission control.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the automatic transmission control nuts.
^ Tighten the nuts to 9 Nm (80 inch lbs.).
3. Install the electrical connector.





4. Install the range select lever cable to the automatic transmission control.
5. Install the console.





6. Install the automatic transmission control lever handle.
7. Install the automatic transmission control lever handle retainer.
8. Connect the battery negative cable.