Transaxle Side Seals
Drive Axle Oil Seal Replacement (Automatic Transaxle-3T40)^ Tools Required
^ J6125-1F Slide Hammer
^ J23129 Axle Seal Remover
^ J28537 Bushing Installer/Remover
^ J34115 Left Side Axle Seal Installer
^ J8092 Driver Handle
Removal Procedure
1. Remove the front fender liner.
2. Remove the drive axle.
Important: Do not damage the seal bore.
3. Remove the seals (117). Use the J23129 and the J6125-1B.
Installation Procedure
1. Install the new oil seals. Use the J34115.
2. Lubricate the seal lip with a light wipe of transmission oil.
Important: Carefully guide the axle shaft past the lip seal. Do not allow the shaft splines to contact any portion of the seal lip surface because damage may occur.
3. Install the drive axle into the transmission case.
4. Install the front fender liner.
5. Lower the vehicle.
Notice: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
6. Fill the transmission to the proper level with DEXRON III oil.
7. Inspect the oil seal for leaks.