Operation CHARM: Car repair manuals for everyone.

Low/Reverse Servo Assembly Replace

Removal Procedure

Caution: Refer to Vehicle Lifting Caution in Service Precautions.

1. Raise the vehicle. Support the vehicle.
2. Remove the oil pan and filter. Refer to Oil Filter and Seal Replacement.
3. Remove the oil feed pipes. Refer to on Feed Pipes Replacement.
4. Remove the three lo and the reverse band servo cover bolts, the servo and the spring.





5. Disassemble, clean and inspect the lo/reverse servo assembly. Refer to Automotive Transmission Transaxle Unit Repair.

Installation Procedure





1. Assemble the lo/reverse servo. Refer to Transmission Unit Repair.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the lo and the reverse band servo cover bolts.
^ Tighten the bolts to 12 Nm (106 inch lbs.).
3. Install the oil feed pipe. Refer to Oil Feed Pipes Replacement.
4. Install the oil filter and pan. Refer to Oil Filter and Seal Replacement.
5. Lower the vehicle.
6. Connect the negative battery cable.
7. Fill the transmission. Refer to Fluid Capacity Specifications.
8. Inspect the transmission fluid level. Refer to Transmission Fluid Checking Procedure.