V5 - Direct Mount
REMOVAL PROCEDURETOOL REQUIRED
J 41790 Compressor Holding Fixture
1. Install the compressor onto the J 41790.
2. Remove the pressure relief valve from the rear head of the compressor
INSTALLATION PROCEDURE
TOOL REQUIRED
J 41790 Compressor Holding Fixture
1. Clean the pressure relief valve seat area of the rear head.
2. Lubricate the O-Ring of the new pressure relief valve with clean 525 viscosity refrigerant oil.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the new pressure relief valve into the compressor.
Tighten
Tighten the pressure relief valve to 9 N.m (80 lb in).
4. Remove the compressor from the J 41790.