Brake Pressure Modulator Valve (BPMV) Replacement
Removal ProcedureCaution: For safety reasons, the brake pressure modulator valve assembly must not be repaired, the complete unit must be replaced. With the exception of the EBCM, no screws on the brake pressure modulator valve assembly may be loosened. If screws are loosened, it will not be possible to get the brake circuits leak-tight and personal injury may result.
1. Turn the ignition switch to the OFF position.
2. Disengage the Connector Position Assurance (CPA) (2) from the connector.
3. Push the lock tab (1) down and then move the sliding connector cover to the open position.
4. Disconnect the Electronic Brake Control Module (EBCM) harness connector (4).
Important: Note the locations of the brake pipes in order to aid in installation.
5. Disconnect the caliper and the wheel cylinder brake pipes (1) from the Brake Pressure Modulator Valve (BPMV) (3).
6. Swing the caliper and the wheel cylinder brake pipes out of the way only after covering the open pipes to avoid dripping or being contaminated.
7. Disconnect the master cylinder brake pipes (2) from the Brake Pressure Modulator Valve (BPMV) (3).
8. Swing the master cylinder brake pipes out of the way only after covering the open pipes to avoid dripping or being contaminated.
9. Remove the upper BPMV bracket mounting nut (3) that connects the upper BPMV mounting bracket to the lower mounting bracket (2).
Notice: When removing the brake pressure modulator valve, protect the vehicle exterior from possible brake fluid spillage. Brake fluid can cause damage to painted surfaces.
10. Remove the EBCM/BPMV assembly (4) from the vehicle.
11. Remove the EBCM (1) from the BPMV (2).
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the EBCM (1) to the BPMV (2).
^ Tighten the four screws that connect the EBCM (1) to the BPMV (2) to 5 Nm (44 inch lbs.).
2. Transfer the upper BPMV mounting bracket to the new BPMV.
3. Install the EBCM/BPMV assembly (4) to the lower mounting bracket (2).
4. Install the nut (3) that connects the EBCM/BPMV assembly to the mounting bracket (2).
^ Tighten the nut (3) to 10 Nm (7 ft. lbs.).
Caution: Make sure brake pipes are correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake, wheel lockup will occur and personal injury may result. The only two ways this condition can be detected are by using a Scan Tool or by doing an Antilock stop.
5. Install the master cylinder brake pipes (2) to the BPMV (3).
^ Tighten the master cylinder brake pipe fittings to 24 Nm (18 ft. lbs.).
6. Install the caliper and the wheel cylinder brake pipes (1) to the BPMV (3).
^ Tighten the caliper and the wheel cylinder brake pipe fittings to 24 Nm (18 ft. lbs.).
7. Connect the EBCM harness connector (4).
8. Push down the lock tab (1) and then move the sliding connector cover back in the home position to lock.
9. Insert the CPA (2) back into place.
10. Perform the Automated Bleed Procedure.
11. Perform the A Diagnostic System Check - ABS.