Brake Pressure Modulator Valve (BPMV) Bracket Replacement
Removal Procedure1. Turn the ignition switch to the OFF position.
2. Remove the EBCM/BPMV assembly (4) from the lower BPMV bracket (2). Refer to Brake Pressure Modulator Valve (BPMV) Replacement.
3. Remove the master cylinder attaching nuts.
4. Move the master cylinder (5) forward just enough to clear the studs on the vacuum brake booster (1).
5. Remove the lower BPMV bracket (2) from the vacuum brake booster (1).
Installation Procedure
1. Install the lower BPMV bracket (2) to the vacuum brake booster (1).
2. Connect the master cylinder (5) to the vacuum brake booster (1).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the master cylinder attaching nuts.
^ Tighten the master cylinder attaching nuts to 27 Nm (20 ft. lbs.).
4. Install the EBCM/BPMV assembly (4) to the lower BPMV bracket (2). Refer to Brake Pressure Modulator Valve (BPMV) Replacement.
5. Perform the Automated Bleed Procedure.
6. Perform the A Diagnostic System Check - ABS.