Operation CHARM: Car repair manuals for everyone.

Starter Heat Shield: Service and Repair

Starter Shield Replacement




REMOVAL PROCEDURE
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the starter motor shield bolts (1 and 3) and nut (2).
3. Remove the starter motor shield from the vehicle.

INSTALLATION PROCEDURE
1. Install the starter motor shield to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the starter shield nut (2) and bolts (1 and 3).

Tighten
^ Tighten to starter motor shield bolt (1) to 30 N.m (22 lb ft).
^ Tighten the starter motor shield bolt (3) to 10 N.m (89 lb in).
^ Tighten the starter motor shield nut (2) to 10 N.m (89 lb in).

3. Lower the vehicle.