Operation CHARM: Car repair manuals for everyone.

Fuel Tank Pressure Sensor Inspection

Fuel Tank Pressure Sensor Inspection




1. Disconnect the fuel tank pressure sensor electrical connector (4).
2. Turn ON the ignition, leaving the engine OFF.
3. Measure the voltage between the 5 volt reference (2) and ground (1) circuits, using a DMM.
Measure
The DMM should read 4.5-5.5 volts.
4. If the DMM does not read the correct voltage, refer to DTC P0450. Testing and Inspection




5. Measure the fuel tank pressure sensor input circuit (1).
Measure
The DMM should read 4.55.5 volts.
6. If the DMM does not read the correct voltage, refer to DTC P0450. Testing and Inspection
7. Turn the Ignition OFF.
8. Reconnect the fuel tank pressure sensor electrical connector.
9. Disconnect the vacuum hose from the fuel tank pressure sensor.




10. Connect a hand held vacuum/pressure pump to the fuel tank pressure sensor.




11. Using a DMM on the DC scale, place one lead on the fuel tank pressure sensor input circuit and the other lead on the Fuel Tank Pressure Sensor ground circuit at the PCM. Measure the output voltage under the following conditions.
^ Apply vacuum to the fuel tank pressure sensor, 2.0 kPa (15 mm Hg, 0.59 in. Hg).
Measure
1.3 - 2.1 volts
^ Release the vacuum from the fuel tank pressure sensor.
Measure
3.0-3.6 volts
^ Apply pressure to the fuel tank pressure sensor 1.5 kPa (0.22 psi)
Measure
4.2 - 4.8 volts
12. If the fuel tank pressure sensor failed any of the above tests, replace the fuel tank pressure sensor.
13. Remove the hand held vacuum pump.
14. Connect the fuel tank pressure sensor vacuum hose.