Control Assembly, HVAC
Removal Procedure1. Remove the center console trim bezel.
2. Remove the two screws (5) and pull the heater control unit (4) forward.
Top View Of Control Assembly:
3. Disconnect the blower speed selector switch electrical connector (2).
4. Remove the following from the heater control unit:
^ the temperature control cable (1)
^ the mode control cable (4)
^ the fresh/recirc control cable (6)
5. Remove the heater control unit.
Installation Procedure
1. Install the heater control unit.
2. Install the following to the heater control unit:
^ the temperature control cable (1)
^ the mode control cable (4)
^ the fresh/recirc control cable (6)
3. Connect the blower speed selector switch electrical connector (2).
4. Install the heater control unit (4) to the I/P. Secure with the two screws (5).
5. Install the center console trim bezel.
6. Adjust the cables as necessary, refer to the following:
^ Temperature Control Cable Adjustment.
^ Mode Control Cable Adjustment.
^ Vent Control Cable Adjustment.