Operation CHARM: Car repair manuals for everyone.

Remote Control Door Lock Receiver Replacement

REMOVAL PROCEDURE

Remote Control Door Lock Receiver Replacement: Removal Procedure:




1. Remove the lip drivers knee bolster reinforcement.
2. Remove the following components from the vehicle:
^ The plastic retainer (1)
^ The left I/P outer air outlet duct (2)

Remote Control Door Lock Receiver Replacement: Removal Procedure:




3. Remove the screw (2) that secures Junction Block 2 (1) and position aside in order to gain clearance to remove the left I/P outer air outlet.

Remote Control Door Lock Receiver Replacement: Removal Procedure:




4. Remove the following components from the vehicle:
^ The screw
^ The left I/P outer air outlet (1)

Remote Control Door Lock Receiver Replacement: Removal Procedure:




5. Disconnect the remote control door lock receiver electrical connector.
6. Remove the following components from the vehicle:
^ The remote control door lock retaining nut
^ The remote control door lock receiver (1) with the mounting bracket attached
7. Depress the retaining tab and remove the mounting bracket from the receiver, if necessary.

INSTALLATION PROCEDURE

Remote Control Door Lock Receiver Replacement: Installation Procedure:




1. Install the remote control door lock receiver to the mounting bracket, it removed.
2. Install the door lock receiver (1) to the vehicle. Secure the receiver with the retaining nut.

Tighten
Tighten the remote control door lock receiver retaining nut to 10 N.m (89 lb in).

3. Connect the remote control door lock receiver electrical connector.

Remote Control Door Lock Receiver Replacement: Installation Procedure:




4. Install the left I/P outer air outlet (1) to the vehicle. Secure the outlet with the screw.

Remote Control Door Lock Receiver Replacement: Installation Procedure:




5. Install the left I/P outer air outlet duct (2) to the vehicle. Secure the outlet duct with the plastic retainer (1).

Remote Control Door Lock Receiver Replacement: Installation Procedure:




6. Reposition Junction Block 2 (1) back into position. Secure the junction block with the screw (2).
7. Install the I/P drivers knee bolster reinforcement.
8. Reprogram the remote control door lock receiver. Refer to Transmitter Programming. Transmitter Programming