Operation CHARM: Car repair manuals for everyone.

Engine Block Heater

Engine Block Indexing 3800 L36 (VIN K) And 3800 L36 (VIN 1):




Engine Block Heater Indexing 3800 L36 (VIN K) And 3800 L36 (VIN 1):





CAUTION: Perform this operation only when the engine is cool or personal injury may result.

REMOVE OR DISCONNECT
1. Drain the engine coolant.
2. Raise and suitably support the vehicle.
3. Radiator air deflector.
4. Engine block heater cord from engine block heater.
5. Loosen engine block heater screw.
6. Engine block heater.

Clean
^ Core plug hole.

INSTALL OR CONNECT

NOTE: Refer to Fastener Notice in Cautions and Notices.

1. Coat of lubricant, GM P/N 12345996 or equivalent, to the engine block heater seal and the cleaned surface of the engine block heater hole.
2. Engine block heater with heating element at 9 O'Clock position.
3. Engine block heater screw.

Tighten
^ Screw to 2 N.m (18 lb. in.).

CAUTION: Engine block heater cord must not contact engine, exhaust pipes, manifold or any moving parts or vehicle damage and/or personal injury may result.

4. Engine block heater cord to engine block heater.
5. Radiator air deflector.
6. Lower the vehicle.
7. Refill the engine coolant.