Case: Service and Repair
REMOVAL PROCEDURE1. Raise and suitably support the vehicle. Refer to Vehicle Lift Points.
2. Remove the reverse lockout solenoid. Refer to Reverse Lockout Solenoid (Front Mounted EBTCM/BPMV), or Reverse Lockout Solenoid (Rear Mounted EBTCM/BPMV).
3. Remove the transmission vent tube retaining bolt.
4. Remove the transmission vent tube.
INSTALLATION PROCEDURE
1. Install the transmission vent tube.
2. Install the transmission vent tube retaining bolt.
^ Tighten the transmission vent tube retaining bolt to 20 Nm (15 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the reverse lockout solenoid. Refer to Reverse Lockout Solenoid (Front Mounted EBTCM/BPMV), or Reverse Lockout Solenoid (Rear Mounted EBTCM/BPMV).
4. Lower the vehicle.