Operation CHARM: Car repair manuals for everyone.

Suspension Control Module: Service and Repair






REMOVAL PROCEDURE

CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live" exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.

1. Disconnect the negative battery cable.
2. Raise the LR floor compartment (2) lid.
3. Gently push down on the ESC module (1) in order to remove from the mounting bracket.
4. Disconnect the ESC module connectors (3).

INSTALLATION PROCEDURE
1. Connect the ESC module connectors (3).
2. Install the ESC module (1) into the mounting bracket.
3. Secure the LR floor compartment (2) lid.

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

4. Connect the negative battery cable.
- Tighten the negative battery cable bolt to 15 Nm (11 ft. lbs.).
5. Program the keyless entry transmitters. Refer to TRANSMITTER PROGRAMMING/SYNCHRONIZATION in KEYLESS ENTRY.