Operation CHARM: Car repair manuals for everyone.

Brake Caliper Replacement (Front)



REMOVAL PROCEDURE
1. Raise the vehicle and support.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.





3. Remove the inlet fitting bolt, inlet fitting, and two gaskets only if the brake caliper housing is being removed from the vehicle.
3.1. Discard the two gaskets.
3.2. Plug the openings in the brake caliper housing and the inlet fitting.





4. Remove the brake caliper guide pin bolts.
5. Remove the brake caliper housing from the brake rotor and the brake caliper mounting bracket.
6. If a brake caliper housing overhaul or replacement is not required, support the brake caliper housing using a wire hook or equivalent to avoid damage to the brake hose.
7. Remove the brake pads only if they are being replaced or if the brake caliper mounting bracket is being removed.

INSTALLATION PROCEDURE
1. Install the brake pads, if removed.
1.1. Install the outboard brake pad with the insulator installed toward the brake caliper housing.
1.2. Install the inboard brake pad with the wear sensor installed nearest the brake caliper piston.
1.3. The wear sensor must be in the trailing position during forward wheel rotation.

2. Install the brake caliper housing over the brake rotor and into the brake caliper mounting bracket.

NOTICE: Refer to Fastener Notice in Service Precautions.





3. Install the brake caliper guide pin bolts.
- Tighten the brake caliper guide pin bolts to 31 Nm (23 ft. lbs.).





4. Install the inlet fitting, two new gaskets and the inlet fining bolt, if removed.
- Tighten the brake caliper inlet fitting bolt to 40 Nm (30 ft. lbs.).
5. Bleed the hydraulic brake system, If the inlet fining was removed. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) in Hydraulic Brakes.
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Tighten the wheel nuts in sequence to 140 Nm (100 ft. lbs.).

7. Lower the vehicle.
8. Refill the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
9. With the engine running, pump the brake pedal slowly and firmly three times to seat the brake pads.
10. Inspect the hydraulic brake system for brake fluid leaks.