Operation CHARM: Car repair manuals for everyone.

Windshield Washer Pump: Service and Repair

REMOVAL PROCEDURE

Washer Pump/Reservoir Replacement: Removal Procedure:




CAUTION: Refer to Battery Disconnect Caution In General Information.

1. Disconnect the negative battery cable.
2. Remove the washer solvent container retainer nuts.
3. Lift the washer solvent container from the wheelhouse.
4. Disconnect the electrical connector from the fluid level sensor.

Washer Pump/Reservoir Replacement: Removal Procedure:




5. Disconnect the electrical connector and the washer hose from the washer pump.

Washer Pump/Reservoir Replacement: Removal Procedure:




6. Drain the washer solvent from the washer solvent container.
7. Remove the washer pump and seal from the washer solvent container.

Washer Pump/Reservoir Replacement: Removal Procedure:




8. Remove the fluid level sensor from the washer solvent container.

INSTALLATION PROCEDURE

Washer Pump/Reservoir Replacement: Installation Procedure:




1. Install the fluid level sensor into the washer solvent container.

Washer Pump/Reservoir Replacement: Installation Procedure:




2. Install the washer pump and seal into the washer solvent container.

Washer Pump/Reservoir Replacement: Installation Procedure:




3. Connect the electrical connector and the washer hose onto the washer pump.

Washer Pump/Reservoir Replacement: Installation Procedure:




4. Connect the electrical connector onto the fluid level sensor.
5. Place the washer solvent container over the studs on the wheelhouse.
6. Install the washer solvent container nuts.

Tighten
Tighten the washer solvent container nuts to 7.5 N.m (66 lb in).

NOTE: Refer to Fastener Notice in General Information.

7. Fill the washer solvent container with washer solvent.

CAUTION: Refer to Battery Disconnect Caution in General in formation.

8. Connect the negative battery cable.