Operation CHARM: Car repair manuals for everyone.

Torque Converter Clutch: Service Precautions

CAUTION: This vehicle is equipped with Supplemental Inflatable Restraint (SIR). Refer to CAUTIONS in "ON-VEHICLE SERVICE" and the SIR Component and Wiring Location view in POWERTRAIN MANAGEMENT before performing service on or around SIR components or wiring. Failure to follow CAUTIONS could result in possible air bag deployment, personal injury, or otherwise unneeded SIR system repairs.

CAUTION: Before removing or installing any electrical unit, or when a tool or equipment could easily come in contact with "live" or "hot at all times" exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or components. Unless instructed otherwise, the ignition switch must be in the "off" or "lock" position.

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for-the application. General Motors will call out those fasteners that require a replacement after removal. General Motors will-also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect 'the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

WARNING: When self-threading fasteners are removed it is important to thoroughly-clean the bolt holes to remove debris created by the thread forming process. In addition, inspect the threads for damage and repair as necessary. Self-threading fasteners may be reused if they are not damaged. However, if a fastener need to be replaced, service fasteners are available and should be used. Self threading fasteners should not be used as replacement fasteners. Service fasteners are recognizable by their color. Service fasteners interior to the transaxle are gold/yellow in color. Service fasteners exterior to the transaxle are a light grey color. Also, service fasteners are approximately 4 mm shorter than self-threading fasteners. Self-threading fasteners are a dark gray/black color.