Cylinder Block Plug Installation
NOTEThe importance of cleanliness during assembly cannot be overstated. Dirt or debris will cause engine damage. An automobile engine is a combination of many machined, honed, polished and lapped surfaces with tolerances that are measured in ten thousandths of an inch. When any internal engine parts are serviced, care and cleanliness are important. A liberal coating of engine oil should be applied to friction areas during assembly in order to protect and lubricate the surfaces on initial operation. Throughout this section, it should be understood that proper cleaning and protection of machined surfaces and friction areas are part of the repair procedure. This is considered standard shop practice even if not specifically stated. Lubricate all moving parts with engine oil or a specified assembly lubricant. This will provide lubrication for initial start up.
1. Install the engine block coolant drain plug.
2. Apply gasket paste GM P/N 1050026 or equivalent to the plug before installation. Tighten Coolant Jacket Plug to 30 Nm (22 ft. lbs.).
3. Install the oil passage plugs.
4. Apply gasket paste GM PIN 12345382 to the plugs before installation. Tighten Oil Passage Plugs to 30 Nm (22 ft. lbs.).