EGR Valve: Service and Repair
Digital EGR Valve Assembly:
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Electrical connector at solenoid.
3. Two base to pad bolts or screws.
4. Digital Exhaust Gas Recirculation (EGR) valve.
INSTALL OR CONNECT
1. EGR valve gasket with "UP" readable after positioning on adaptor.
2. EGR valve assembly.
3. Two (2) bolts, finger tight.
Tighten
Bolts to 15 Nm (11 lb. ft.).
Additionally torque Bolts to 30 Nm (22 lb. ft.).
4. Electrical connector at solenoid.
5. Negative battery cable.