Fuel Pressure Test Port: Service and Repair
Engine Compartment Pipe/Hose Assemblies Replacement:
Remove or Disconnect:
1. Disconnect negative battery cable
2. Clean around fuel pressure connection
3. Relieve fuel system pressure
4. Remove fuel pressure connection and seal
Install or Connect:
1. Install new seal on fuel pressure connection and re-connect fuel feed hose.
2. Tighten fuel filler cap
3 Connect negative battery cable
Inspect:
Turn ignition switch to "ON" position for two seconds, then turn to "OFF" for ten seconds. Again turn to "ON" position and check for fuel leaks.