Operation CHARM: Car repair manuals for everyone.

Water Pump: Service and Repair

Water Pump:




Water Pump Fasteners:






REMOVE OR DISCONNECT
1. Drain radiator assembly, refer to System Draining, Flushing and Filling.
2. Air duct and electrical connector.
3. Top coil of coil pack.
4. Loosen tensioner pulley bolt/screw.
5. Heater hose from pump.
6. Loosen water pump pulley bolts/screws (27).
7. Power steering bracket bolts/screws.
8. Serpentine belt.
9. Water pump pulley (28).
10. Power steering pump bracket and pump.
11. Water pump bolts/screws (29).
12. Engine front cover bolts/screws (30).
13. Water pump cover bolts/screws (31).
14. Water pump assembly (32) and water pump gasket (33).
15. Clean all gasket surfaces and water pump bolts/screws.

INSTALL OR CONNECT
1. New water pump gasket.
2. Water pump assembly.
3. Water pump cover bolts/screws and tighten to 45 Nm (33 lb ft).
4. Engine front cover bolts/screws and tighten to 11 Nm (97 lb in).
5. Water pump bolt/screw and tighten to 10 Nm (89 lb in).
6. Power steering pump and bracket.
7. Water pump pulley.
8. Serpentine belt.
9. Power steering pump bracket bolts/screws and tighten to 40 Nm (30 lb ft).
10. Heater hose to pump.
11. Top coil of coil pack.
12. Electrical connector to alternator.
13. Air duct and electrical connector.
14. Add engine coolant, refer to System Draining, Flushing and Filling.
15. Inspect for leaks, after running engine to normal operating temperature.