Operation CHARM: Car repair manuals for everyone.

With Air Conditioning

CIRCUIT OPERATION
The Blower Motor speed is determined by the setting of the Blower Switch in the Heater and A/C Control Assembly. With the switch in the LO position, all of the Blower Resistors are in the circuit with the Blower Motor. The resistors reduce the voltage applied to the motor so that it runs slowly. In the M1 and M2 positions. the Blower Switch bypasses some of the resistors. raising the voltage and increasing the motor's speed.

Voltage is applied to the Blower Motor through the contacts of the A/C Blower Relay. When the Blower Switch is in the HI position, battery voltage is supplied through the ORN wire to the coil of the A/C Blower Relay. The relay is energized and its contacts supply battery voltage directly to the Blower Motor from Fusible Link B.

When the A/C Mode Selector is in the OFF position, no voltage is applied to the Blower Switch and Blower Motor, so the blower does not run. In all other positions, the blower will operate as described.