Operation CHARM: Car repair manuals for everyone.

Canister Purge Control Valve: Testing and Inspection



To test the canister control valve proceed as follows:

^ Apply a short length of hose to the tube labeled "CARB BOWL" on control valve and blow through it. If air does not come out of the tubes labeled "CAN" AND "PURGE" at the same time, then the valve is bad. If the air does pass through both tubes then proceed to next step.

^ Use a hand vacuum pump and apply 15" Hg of vacuum to the tube labeled "MAN VAC" on the diaphragm cover. The diaphragm should hold vacuum for at least 20 seconds. If it does not, then control valve is bad. If it does hold vacuum then proceed to next step.

^ With vacuum still applied to the "MAN VAC" tube, blow into the tube labeled "CARB BOWL." If air does not pass through either the tube labeled "CAN" or "PURGE" then the control valve is ok. If air does pass through either of the tubes then the valve is bad.