Throttle Body Fuel Injection System
Fig. 093 - Wiring Diagram for Chart C-7 EGR Check. VIN E:
CHART C-7
EXHAUST GAS RECIRCULATION (EGR) CHECK
5.0L (VIN E) "F" SERIES (TBI)
Circuit Description: The ECM operates a solenoid to control the exhaust gas recirculation (EGR) valve. This solenoid is normally closed. By providing a ground path, the ECM energizes the solenoid which then allows vacuum to pass to the EGR valve. The ECM control of the EGR is based on the following inputs:
a. Engine coolant temperature - above 25°C.
b. TPS-off idle
c. MAP
If Code 24 is stored, use that chart first.
Fig. 092 Chart C-7 EGR Check:
Test Description: Numbers below refer to circled numbers on the diagnostic chart.
1. Checks for solenoid stuck open.
2. Checks for solenoid always being energized.
3. Grounding test terminal will energize the solenoid and vacuum will drop.
4. Negative backpressure valve should hold vacuum with engine "OFF".
5. When engine is started, exhaust backpressure should cause vacuum to bleed off and valve to fully close.
6. 5.0L engines have a manifold vacuum source which should have at least 7 Hg at idle.