Operation CHARM: Car repair manuals for everyone.

Vehicles Involved, Service and Parts Information

Involved are some 1982 Chevrolet Camaro Models equipped with RPO LU5 (5.0L) engine and RPO NB2 (California Emissions) within the following parameters:

Plant From Through

Van Nuys CL168647 CL172674

Involved vehicles have been identified by Vehicle Identification Number Computer Listings. Computer listings contain the complete Vehicle Identification Number, owner name and address data, and are furnished to the involved dealers with the campaign bulletin. Owner name and address data furnished will enable dealers to follow-up with owners involved in this campaign.

These listings may contain owner names and addresses obtained from State Motor Vehicle Registration Records. The use of such motor vehicle registration data for any other purpose is a violation of law in several states. Accordingly, you are urged to limit the use of this listing to the follow-up necessary to complete this campaign. Any dealer not receiving a computer listing with the campaign bulletin was not shipped any involved vehicles.

OWNER NOTIFICATION

Owners will be notified of this campaign on their vehicles by Chevrolet Motor Division (see copy of Owner Letter included with this bulletin).


DEALER CAMPAIGN RESPONSIBILITY

Dealers are to service all vehicles subject to this campaign regardless of mileage, age of vehicle, or ownership, from this time forward.

Whenever a vehicle subject to this campaign is taken into your new or used vehicle inventory or it is in your dealership for service in the future, you should take the steps necessary to be sure the campaign correction has been made.


SERVICE PROCEDURE

1. Raise vehicle.

2. Disconnect speedometer cable.

3. Remove retainer bolt, retainer, sleeve, speedometer driven gear and "O" ring seal as referenced on page 7A-10 of the 1982 Camaro Shop Manual.

DISCARD DRIVEN GEAR ASSEMBLY AND ADAPTER PARTS NOT TO BE REUSED

4. Install new "O" ring seal, P/N 6264903, to new sleeve assembly, P/N 345215.

5. Install new driven gear, P/N 3987918, (18 tooth brown), and sleeve assembly, P/N 345215, and secure in position reusing removed retainer and retainer bolt, torque retainer bolt to 36-48 in.lbs. (4.0-5.5 N-m).

6. Reconnect speedometer sleeve assembly and lower vehicle.

7. Install "Campaign Identification Label", according to the instructions contained in this bulletin.


PARTS INFORMATION

Dealers are requested to order the parts required to complete this campaign from WDDGM.

Part Number Quantity Per Vehicle Description

3987918 1 Speedometer
Driven Gear (18 Tooth Brown)

345215 1 Sleeve Assy.

6264903 1 "O" Ring Seal