Cruise Control - Oscillation
Number:REISSUE 82-T-85Section: XII
Date: Feb., 1983
Subject: CRUISE CONTROL OSCILLATION - 1982 CAMARO WITH V8 ENGINE (RPO LG4 OR LU5)
TO: ALL CHEVROLET DEALERS
This bulletin suspersedes the previous bulletin 82-T-85 dated August, 1982.
Step #5 has been revised; removing and replacing of cruise control transducer.
Some 1982 Camaros with V8 engines (RPO LG4 or LU5), may exhibit varying degrees of speed oscillation after engaging the cruise control.
A new transducer has been released for vehicles equipped with the engines noted above and entered production on approximately June 15, 1982.
Vehicles exhibiting this condition can be corrected by following the procedures noted below:
1. Check cruise control cable for proper routing and adjustment utilizing applicable "Cruise Control Cable Adjustment" procedure in 1982 Camaro Shop Manual (page 9-10).
FIGURE 1:
2. Remove orifice cup from the larger of the two (2) ports on the front of the transducer (Figure 1).
3. Adjust variable orifice located on the side of the transducer by loosening the lock nut and turning the port inward 1/2 turn (this is required to maintain lock-up speed accuracy).
4. Evaluate vehicle for cruise control stability and lock-up speed accuracy. If additional adjustment to variable orifice is required, see "Engagement-Cruising Speed Zeroing" procedure in 1982 Camaro Shop Manual (page 9-8).
5. The transducer can now be repaired rather than replaced. Delco service centers are now capable (per AC Delco Bulletin 30-37-1) of remanufacturing a 25030560 transducer, converting it to a 25031907 transducer.
Labor Operation Number: R1120
Labor Time .3 hours