Operation CHARM: Car repair manuals for everyone.

Drive Pinion Assemble

Drive Pinion Assemble

^ Tools Required
- J 42164 Pinion Gear Holder
- J 42170 Bearing and Race Installer
- J 42172 Bearing Race Installer/Spanner Wrench





1. Install the bearing (27) onto the pinion shaft using the J 42170, J 42164, and a hydraulic press.





2. Assemble the pinion shaft (1119), spacer (29), and bearing (31) into the housing/cage (4).





3. Press the bearing onto the pinion shaft using J 42170, J 42164, and a hydraulic press.

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the nut onto the pinion shaft using a torque wrench, J 42172, and J 42164.
^ Tighten the nut to 500 Nm (370 ft. lbs.).
5. Using a punch, stake the areas of the nut into the notches in the end of the pinion shaft.
6. Measure the rotating torque of the pinion shaft using the J 42164. A properly assembled pinion shaft and bearings should have a rotating torque of 1.4 - 2.8 Nm (12 - 25 inch lbs.).