Operation CHARM: Car repair manuals for everyone.

Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake




Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake

Removal Procedure

1. Turn the ignition OFF.

Note: Do not remove the engine control module (ECM) from the ECM bracket.

Do not remove the ECM redundant ground wire from the ECM.

2. Remove the ECM bracket bolts and reposition the ECM bracket in order to provide access.

Note: Do not disconnect the power steering fluid lines/hoses from the reservoir.

3. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Remote Power Steering Fluid Reservoir Replacement (LH2) (Service and Repair)Remote Power Steering Fluid Reservoir Replacement (LY7) (Service and Repair).




4. Remove the camshaft position (CMP) sensor electrical connector.




5. Remove the CMP sensor bolt.
6. Remove the CMP sensor.

Installation Procedure




1. Install the CMP sensor.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the CMP sensor bolt.

Tighten the CMP sensor bolt to 10 Nm (89 lb in).




3. Install the CMP sensor electrical connector.
4. Install the ECM bracket with the ECM. Refer to Engine Control Module Replacement (Service and Repair).
5. Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement (LH2) (Service and Repair)Remote Power Steering Fluid Reservoir Replacement (LY7) (Service and Repair).