Operation CHARM: Car repair manuals for everyone.

Shift Cable: Service and Repair



Automatic Transmission Range Selector Cable Replacement

Removal Procedure

1. Caution: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.

Remove the air cleaner intake duct.





2. Remove the A/T range selector cable from the wiring harness clip or strap.





3. Remove the A/T range selector cable retainer.





4. Remove the A/T range selector cable from the A/T range selector lever.
5. Remove the A/T range selector cable from the A/T range selector cable bracket.





6. Remove the left knee bolster.
7. Remove the A/T range selector cable from the shift control lever.





8. Install a piece of mechanics wire to the end of the A/T range selector cable.
9. Remove the A/T range selector cable through the hole in the cowl.

Installation Procedure

Caution: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.





1. Install the A/T range selector cable through the hole in the cowl.
2. Remove the mechanics wire from the end of the A/T range selector cable.





3. Install the A/T range selector cable to the shift control lever.
4. Install the left knee bolster.





5. Properly route and position the A/T range selector cable.





6. Install the A/T range selector cable to the A/T range selector cable bracket.
7. Install the A/T range selector cable to the A/T range selector lever.





8. Install the A/T range selector cable retainer.





9. Place the transaxle in the NEUTRAL position.
10. Place the shift control in the NEUTRAL position.
11. Connect each cable section to the following before connecting the 2 cable sections.
1. Insert the metal end fitting of the shift control cable into the transaxle cable end.
2. Use the molded end fittings to push the metal end fitting of the shift control cable and the transaxle cable end together until the metal post snaps into place.

12. Depress the adjuster clip once. This mobilizes the adjuster housing toward the transaxle end fitting.
13. Line up the end fittings so they slide together until you feel the parts cam together and lock.





14. Depress the adjuster clip completely. This locks the cable into its adjusted service position.
15. Pull the conduit in the opposite direction to assure full system adjustment of the shift cable.





16. Important: The horseshoe clip with the tab is flush when fully engaged.

Ensure the conduit is fully engaged.





17. The horseshoe clip with the tab is not flush when not fully engaged.





18. Install the A/T range selector cable to the wiring harness clip or strap.
19. Adjust the A/T range selector cable.
20. Install the air cleaner intake duct.