Solenoid Test - Pressure Hold
This test activates the selected wheel circuit inlet valve, placing the valve in the pressure hold position. When the valve is in the pressure hold position, the valve will not allow master cylinder pressure to be delivered to the hydraulic wheel circuit. This is done under actual operating conditions when the EBCM determines that the wheel is moving too slowly. The EBCM holds additional master cylinder pressure from the hydraulic wheel circuit in an attempt to allow the circuit to rotate at an appropriate speed. The scan tool commands the valve to close. This should allow the technician to spin the wheel even though an assistant is applying pressure to the brake pedal.Perform the following test:
1. Turn OFF the ignition.
2. Install a scan tool.
3. Turn ON the ignition, with the engine OFF.
4. Raise the vehicle. Refer to Vehicle Lifting. Ensure that all of the wheels are about 15 cm (6 inch) off of the floor.
5. Place the gear selector in the NEUTRAL position.
6. Select the Special Functions from the DRP/ABS/TCS/TIM/VSES menu.
7. Select the Solenoid Test. Have an assistant command Inlet Valve Solenoid of the appropriate wheel using the scan tool.
8. Have the assistant press and hold the brake pedal.
9. Attempt to move the wheel being tested by hand. The wheel should move even though the assistant is applying pressure to the brake pedal. The front wheels may be difficult to turn by hand, but may be moved if the system is working properly.