Automatic Control (RPO C68, CJ2)

HEATER CORE (RPO C68 or CJ2) Removal and Installation

TOOL REQUIRED:

J 37097 Mubea Hose Clamp Pliers (or equivalent)

REMOVE OR DISCONNECT

1. Drain cooling system.

Heater Hoses:

2. Heater hoses from heater core, using J 37097.
3. Air mix valve actuator, refer to Programmer. Service and Repair
4. Retaining screws and heater core cover.
5. Retaining screws and heater core from vehicle.

INSTALL OR CONNECT

1. Heater core into vehicle and attaching screws.

Tighten
^ Screws to 1.4 Nm (12 lb in)

2. Heater core cover and attaching screws.

Tighten
^ Screws to 1.4 Nm (12 lb in)

3. Air mix valve actuator, refer to Programmer. Service and Repair

Heater Hoses:

4. Heater hoses to heater core using tool J 37097. (or equivalent)
5. Fill cooling system.