Operation CHARM: Car repair manuals for everyone.

Fuel Pressure Regulator: Service and Repair

Upper And Lower Manifold Assemblies:




Accelerator Cam Splash Shield:





Removal

1. Relieve fuel system pressure.
^ Refer to the "Fuel Pressure Relief Procedure."
2. Disconnect negative battery cable.
3. Remove vacuum hose from regulator. Refer to SERVICE PRECAUTIONS.
4. Remove fuel return pipe clamp.
5. Remove fuel return pipe and O-ring from regulator.
^ Discard O-ring.
6. Remove pressure regulator bracket attaching screw.
7. Remove pressure regulator assembly and O-ring.
^ Discard O-ring.

Inspection
^ If fuel pressure regulator is to be reinstalled, inspect filter screen for contamination. If contaminated, remove and discard.

Installation
1. Lubricate new pressure regulator O-ring with clean engine oil, then install on pressure regulator.
2. Install pressure regulator assembly onto manifold.
3. Install pressure regulator bracket attaching screw coated with appropriate thread-locking material. Tighten pressure regulator bracket attaching screw to 3.5 N-m (31 lb. in.).
4. Install vacuum hose to regulator.
5. Lubricate new fuel return pipe O-ring with clean engine oil, then install on end of pipe.
6. Attach fuel return pipe to pressure regulator. Tighten fuel return pipe attaching nut 30 N-m (22 lb. in.).
7. Attach fuel return pipe clamp attaching nut to lower manifold assembly.
8. Tighten fuel fIller cap.
9. Reconnect negative battery cable.

Inspection
^ Turn ignition switch to the "ON" position for two seconds, then turn to the "OFF" position for ten seconds. Again turn to the "ON" position and check for fuel leaks.